While we are sending to the radio, We move the screens around to show what is going on. If the ID's area doesn't move into view as we program the radio, I suspect you may not have set that system up with a "TYPE of Trunking selection" (Far right GREEN area)

It's difficult to MANUALLY see what's in the radio. SO I would suggest once you program the radio, you do the 'reverse' and READ what you just put in. Once that is done, using the bottom grid's scroll bar move over to the far right BRIGHT GREEN area and see the if the ID's are really there. If they are, then you need to figure out how to use the radio.... LOOK for how to put the radio in CLOSED (ID monitor only) mode and then I think you will get the hang of what you want to do.

IF they are NOT, then make sure you actually set the radio's bank (in the grid) for TRUNKING, we only program ID's IF the system IS trunking.... May be that's the problem.


I realize that this has probably been asked and answered a hundred
times,, BUT,,   I finally got the pc and the pro 95 on speaking
terms... I went through the freq database and brought everything up to
When I try to load into scanner, as soon as I click on "Program entire
Pro 98"   the trunking info on the right side of the screen disappears.
When programing is done, on the trunked banks all I get are the freqs
and none of the trunking data. All the radio traffic comes in, not what
I have selected in the database..
What am I doing wrong??

Lite plus    ver  1.2.5

Yahoo! Groups Links

<*> To visit your group on the web, go to:

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    (Yahoo! ID required)

<*> To change settings via email:

<*> To unsubscribe from this group, send an email to:

<*> Your use of Yahoo! Groups is subject to:

Computer Aided Technologies
 - http://www.scancat.com -
Order Toll Free or Order On Line
(USA Orders Only ) 1-888-722-6228
(NON USA Orders  ) 1-318-687-4444
(Tech Support    ) 1-318-687-2555
(  Fax Line      ) 1-318-686-0449